Characterization of shorted dipole antennas for low-cost RFID reader applications

This article presents a comprehensive study on shorted dipole antennas aiming for low-cost radio frequency identification (RFID) reader applications. Starting from a low-profile shorted bowtie dipole antenna, it is found that by varying the shorting wall position, three different types of resonant antennas could be realized with different radiation features. A low-profile planar inverted F antenna (PIFA) -type dipole is obtained by moving the shorting wall toward the feeding, which exhibits a low resonance frequency without obvious back lobe radiation or sidelobes. When the shorting wall is placed in the middle of the radiating patch, a mushroom-type dipole antenna can be built. A zeroth-order mode is also observed. This structure differs from the magnetoelectric dipole due to a low-profile structure. Placing the wall toward the end of the dipole arm leads to a loop-type antenna with a broader beam and a reduced gain. It also shifts the resonance toward the higher frequency. Based on the PIFA- and mushroom-type structures, two circularly polarized antennas with crossed shorted dipoles are designed and investigated carefully. Finally, two optimized, compact, and low-cost RFID reader antennas based on simple metal stamping process and screws are designed, fabricated, and tested, showing an excellent RF reading range. This study demonstrates that for the shorted dipole antennas, miniaturization and bandwidth control can be achieved simultaneously. Particularly, for higher gain and smaller size, the shorting wall should be placed close to the feeding to suppress the loop mode. For omnidirectional radiation, the loop mode should be enhanced by moving the shorting wall close to the end of the dipole arm.